AMCC 3ware 9650SE-2LP Podręcznik Użytkownika Pobierz pdf (Strona 280)

Troubleshooting

268 3ware SAS/SATA RAID Software User Guide, Version 9.5.1

0009 Drive timeout detected

Event Type

Error

Cause

A drive has failed to respond to a command from a 3ware RAID controller

within the allowed time limit (20 secs.). After sending this error message, the

controller will attempt to recover the drive by sending a reset to that drive and

retrying the failed command.

Possible causes of drive time-outs (also known as ATA-Port time-outs)

include a bad or intermittent disk drive, power cable or interface cable.

Action

If you have checked hardware connections and no cause other than the drive

can be found, replace the drive.

You may also want to use the drive manufacturer’s diagnostic and repair

utilities on the drive.

See Also

For links to drive manufacturer diagnostic utilities and troubleshooting

advice, see

http://www.3ware.com/KB/article.aspx?id=14924.

“Basic Troubleshooting: Check This First” on page 251

000A Drive error detected

Event Type

Error

Cause

A drive has returned an error to the 3ware RAID controller that it is unable to

complete a command. The error type is not a time-out (000A) or uncorrected

ECC (0026).

This message may be seen as part of a recovery operation initiated by the

3ware RAID controller on the drive. One possible cause is multiple write

commands to a sector forcing the drive to remap a defective sector. This

message may be seen if error recovery operations initiated by the 3ware

RAID controller are unsuccessful.

1 2 ... 275 276 277 278 279 280 281 282 283 284 285 ... 360 361

Brak uwag

AMCC 3ware 9650SE-2LP Podręcznik Użytkownika Strona 280